ORDER OF THE MINISTER OF THE INDUSTRY AND INFRASTRUCTURE DEVELOPMENT OF THE REPUBLIC OF KAZAKHSTAN

of February 24, 2022 No. 103

About approval of requirements to the technical means used in case of examination

According to Item 6 of article 107 of the Law of the Republic of Kazakhstan "About use of airspace of the Republic of Kazakhstan and activities of aircraft" PRIKAZYVAYU:

1. Approve the enclosed requirements to the technical means used in case of examination.

2. To provide to committee of civil aviation of the Ministry of the industry and infrastructure development of the Republic of Kazakhstan:

1) state registration of this order in the Ministry of Justice of the Republic of Kazakhstan;

2) placement of this order on Internet resource of the Ministry of the industry and infrastructure development of the Republic of Kazakhstan.

3. To impose control of execution of this order on the supervising vice-minister of the industry and infrastructure development of the Republic of Kazakhstan.

4. This order becomes effective after ten calendar days after day of its first official publication.

Appendix

to the Order of the Minister of the industry and infrastructure development of the Republic of Kazakhstan of February 24, 2022 No. 103

Requirements to the technical means used in case of examination

Chapter 1. General provisions

1. These requirements to the technical means used in case of examination (further - requirements), are developed according to Item 6 of article 107 of the Law of the Republic of Kazakhstan "About use of airspace of the Republic of Kazakhstan and activities of aircraft" and establish requirements to the technical means used in case of examination.

These requirements extend to the technical means used in case of examination of aviation safety by service of the airport (airfield).

2. The terms and determinations used in these requirements:

1) the equipment for detection of explosive substances (detectors of vapors and particles of explosive substances) - the engineering device intended for detection of vapors or microparticles of explosive substances;

2) the technical means used in case of examination - special fittings, held for use independently or as part of any system when implementing examination of passengers, cabin baggage, load, baggage, mail, onboard inventories, members of crews of air vehicles, aeronautical personnel;

3) portable (manual, figurative) the metal detector - the engineering device intended for determination of the specific location on body of the person of metal subject;

4) X-ray-television installation - the engineering device intended for visual identification of metal objects;

5) the stationary metal detector - the engineering device intended for determination on body of the person of metal objects.

Chapter 2. Requirements to the technical means used in case of examination

3. The equipment for detection of explosive substances (detectors of vapors and particles of explosive substances) shall:

1) to have sensitivity on detection of explosive substances with which the product which shall be not worse than 1x10-14 grams on cubic centimeter, but at the same time, time of cycle of the analysis of vapors of explosive substances - no more than 60 seconds, product response time for availability of vapors of explosive substances - no more than 5 seconds, readiness time for the following cycle of selection - no more than 30 seconds is intended for work, time of exit to operational mode shall not exceed 35 minutes after inclusion;

2) to work both from the network power supply unit, and from autonomous source (the battery, the accumulator) of 9-12 volts;

3) to have the sound and light alarm installation working irrespective of the operator, at the same time the level of sound signal of alarm shall be well distinguishable against the background of noise of the modern airports, the indicator of discharge of the autonomous power source working in case of 70% discharge (on tension) power sources;

4) to have warranty period of operation at least 1 year from the moment of commissioning, average term of service - at least 6 years, warranty period of storage - at least 1 year from the moment of product output;

5) to allow to make diagnostics and repair on site of operation;

6) to have the system of protection stopping giving of current flow in case of exceeding of operational loadings and defect, working capacity control facility in the course of its operation;

7) to conform to all requirements during the work in the round-the-clock mode, time between failures - at least 6000 hours, time of scheduled works - less than 5% of operation time, warranty period of operation - at least 1 year from the moment of commissioning, average term of service - at least 6 years, warranty period of storage - at least 1 year from the moment of product output.

4. Portable (manual, figurative) the metal detector shall:

1) to provide detection of metal objects (steel plate of 100х100х1 millimeters in size) at distance of 0,12-0,15 of meters with traverse speed of the 0,2-0,5 device of meters per second, to have the acoustic alarm of availability of metal subject, to ensure normal functioning in the conditions of electromagnetic situation of the modern airports;

2) to have warranty period of operation at least 1 year from the moment of commissioning, average term of service - at least 3 years, warranty period of storage - at least 1 year from the moment of product output;

3) to allow to make diagnostics and repair on site of operation;

4) during the work from the autonomous power source product to keep detective characteristics in case of 60% discharge (on tension) power sources, to provide duration of continuous work of product from the autonomous power source at least 10 hours.

5. X-ray-television installation shall:

1) to distinguish firearms metal and nonmetallic, its details, ammunition of all calibers, grenades and other types of weapon of fragmental/discontinuous action, knives, bludgeons, swords, explosive substances of military and commercial assignment, detonators and clock mechanisms, electric and electronic products, sources of electrical power;

2) to have the following characteristics of the generator of X-radiation and quality of the image in operational conditions:

penetrating power - 27 millimeters on steel;

resolution capacity - 0,1 of millimeters;

anode voltage: nominal - 160 kilowatts, working - 140 kilowatts;

tube current - 0,7 milliampere;

Disclaimer! This text was translated by AI translator and is not a valid juridical document. No warranty. No claim. More info