Document from CIS Legislation database © 2003-2020 SojuzPravoInform LLC

ORDER OF THE MINISTER OF LABOUR AND SOCIAL PROTECTION OF THE POPULATION OF THE REPUBLIC OF KAZAKHSTAN

of November 3, 2020 No. 422

About approval of the Single wage rate book of works and professions of workers (release 32)

According to subitem 16-1) of Article 16 of the Labor code of the Republic of Kazakhstan of November 23, 2015 PRIKAZYVAYU:

1. Approve the Single wage rate book of works and professions of workers (release 32) according to appendix to this order.

2. To provide to department of work and social partnership of the Ministry of Labour and Social Protection of the population of the Republic of Kazakhstan in the procedure established by the legislation:

1) state registration of this order in the Ministry of Justice of the Republic of Kazakhstan;

2) placement of this order on official Internet resource of the Ministry of Labour and Social Protection of the population of the Republic of Kazakhstan after its official publication;

3) within ten working days after state registration of this order submission to Department of legal service of the Ministry of Labour and Social Protection of the population of the Republic of Kazakhstan of data on execution of the actions provided by subitems 1) and 2) of this Item.

3. Declare invalid the order of the Minister of Labour and Social Protection of the population of the Republic of Kazakhstan of September 19, 2012 No. 361-p-m "About approval of the Single wage rate book of works and professions of workers (release 32)", is registered in the Register of state registration of regulatory legal acts for No. 7944, it is published in the Kazakhstanskaya Pravda newspaper of May 14, 2013 for No. 162-163 (27436-27437).

4. To impose control of execution of this order on the first vice-Minister of Labour and Social Protection of the population of the Republic of Kazakhstan Sarbasov A. A.

5. This order becomes effective after ten calendar days after day of its first official publication.

Minister of Labour and Social Protection of the population of the Republic of Kazakhstan

B. Nurymbetov

 

It is approved

Ministry of Education and Science of the Republic of Kazakhstan

 

It is approved

Ministry and ndustriya and infrastructure development of the Republic of Kazakhstan

 

Appendix

to the Order of the Minister of Labour and Social Protection of the population of the Republic of Kazakhstan of November 3, 2020 No. 422

Single wage rate book of works and professions of workers (release 32)

Chapter 1. Introduction

1. Single wage rate book of works and professions of workers (release 32) (further - ETKS (release 32) contains works on chemical photographic production.

2. ETKS (release 32) is developed by the Ministry of Labour and Social Protection of the population of the Republic of Kazakhstan.

3. Tariff and qualification characteristics are applied during the tariffing of works and assignment of qualification categories by the worker in the organizations irrespective of form of their property and forms of business where there are productions and work types specified in this ETKS (release 32).

Chapter 2. Tariff and qualification characteristics of professions of workers according to categories for works on chemical photographic production

Paragraph 1. The bureaucrat of preparation of the showing paste, the 3rd category

4. Characteristic of works:

conducting engineering procedure of production of capsules with the showing paste or separate transactions of engineering procedure of preparation of the showing paste for photoset "Moment";

weighing of the components which are part of the showing paste, and the stabilizing solution;

loading of components in the mixer;

observation of hashing of initial solutions;

packing of the showing paste in hermetic reservoirs;

dosage of the stabilizing solution in tampons and stacking in test tubes;

quality check of the varnished foil;

foil charging in the automatic machine;

installation of pressure head tank with the showing paste and connection to the dosing pump;

control and regulation of dose of the showing paste in the capsule, temperatures and durations of formation of capsules, durabilities of seams of capsules;

preparation of the marking device and installation of cartridges for suitable capsules.

5. Shall know:

engineering procedure of production of capsules and preparation of the showing paste;

physical and chemical properties of the used semifinished products, materials and finished goods.

Paragraph 2. The bureaucrat of preparation of the showing paste, the 4th category

6. Characteristic of works:

conducting engineering procedure of preparation of the showing paste and the stabilizing solution for photoset "Moment";

calculation of hinge plate and weighing of the components which are part of the showing paste and the stabilizing solution;

preparation of the stabilizing solutions, finishing them to the set concentration and amounts;

introduction of the showing and fixing substances, finishing viscosity of the showing paste to provided by regulations and determination of its quality;

preparation of the stabilizing solution: loading of initial solutions in reservoir with heating, inclusion of mixer, introduction of additives, filtering solution;

management of bureaucrats of preparation of the showing paste of lower qualification.

7. Shall know:

engineering procedure of preparation of the showing paste and the stabilizing solution;

physical and chemical properties of the applied components, materials and finished goods;

the device of the served equipment.

Paragraph 3. The operator on servicing of the pro-attendance processor, the 7th category

8. Characteristic of works:

conducting chemical and photographic processing of import color positive films on process of "ECP-2B" on the integrated electronic and mechanical processor in the conditions of not actinic lighting and in the dark;

the choice and regulation of the mode of manifestation of film on the control panel of the processor;

observation of the speed of movement of tape on path of the processor, the level of solutions in tanks, operation of the zatirochny mechanism, blocks of separate processing of soundtrack and chemical control;

control of technical condition of surface of film in processing;

completing of the processed film according to orders;

maintaining the accompanying documentation.

9. Shall know:

technology of processing of color and black-and-white negative and positive films;

the device of the pro-attendance processor, appointment and work of its main parts and function blocks, work of REK - the elevator;

structure and purpose of the processing solutions;

regulations of the modes of manifestation according to sensitometrichesky data.

10. Education is required technical and professional (average special and professional).

Paragraph 4. The operator on servicing of the pro-attendance processor, the 8th category

11. Characteristic of works:

conducting chemical and photographic processing of import color positive films on process of "ECP-2B" and negative films on process of "ECN-2" on the electronic and mechanical processor in the conditions of not actinic lighting and in the dark;

choice and regulation of the modes of manifestation of films;

observation of the speed of movement of tape on path of the processor, the level of solutions in tanks, operation of the zatirochny mechanism, blocks of separate processing of soundtrack and chemical control;

completing of the processed film according to orders;

maintaining the accompanying documentation.

12. Shall know:

technology of processing of color and black-and-white negative and positive films;

structures and purposes of the processing solutions;

influence of the processing solutions on photographic properties of films;

regulations of the modes of manifestation and requirements imposed to quality of the processed film.

13. Education is required technical and professional (average special and professional).

Paragraph 5. Bureaucrat of tanning and drying of fibrous casing, 4th category

14. Characteristic of works:

conducting continuous process of tanning and drying of fibrous casing on multiple-pass drying lines under the leadership of the bureaucrat of tanning and drying of fibrous casing of higher qualification;

gas station of damp fibrous casing to the multiple-pass automatic drying transfer line, regulation of the set diameter and single thickness of fibrous casing on all length;

elimination of breaks of fibrous casing and its gas station in the reeling-up device;

control of quality of winding and transfer of products on the following transactions;

identification and elimination of violations of the technological mode, malfunctions in operation of the served equipment;

rejection of non-standard products;

sampling.

15. Shall know:

the device and the principle of operation of the capital and service equipment, the applied means of automatic equipment and instrumentations;

technological scheme of drying and tanning of fibrous casing;

parameters of the technological mode and regulation of process of tanning and drying of fibrous casing;

rules of sampling.

Paragraph 6. Bureaucrat of tanning and drying of fibrous casing, 5th category

16. Characteristic of works:

conducting continuous process of tanning and drying of fibrous casing on multiple-pass automatic drying transfer lines;

tanning of fibrous casing tannic liquid, its drying and gas station in the reeling-up device;

observation and regulation on indications of instrumentations, to visual survey, analysis results and charts of correctness of watering of fibrous casing tannic liquid, degrees of its tanning, temperature moisture conditions of drying, quality of winding;

control of temperature and humidity of air, moisture content in fibrous casing, its diameter and thickness;

servicing of multiple-pass channel lines, ventilating devices, heaters, communications, armature, instrumentations and means of automatic equipment;

preparation of the served equipment for repair and its acceptance from repair;

conducting entries in the production magazine;

management of bureaucrats of tanning and drying of fibrous casing of lower qualification and control of observance of the technological mode by them;

subadjustment of the served equipment.

17. Shall know:

physical and chemical process and technological scheme of drying and tanning of fibrous casing;

standards and specifications on finished goods.

Paragraph 7. Measuring instrument of fibrous casing, 3rd category

18. Characteristic of works:

measuring off of the set length of fibrous casing on the measuring installation;

check of work of automatic lock-out and counter;

selection, movement and installation on the winding-off rack of reels with cover;

rejection of cover in case of measuring off;

regulation of process of winding of cover;

binding in bunches, cutting on pieces of the set length, I will eat also stacking of cover;

marking of bunches of cover;

elimination of defects in work of the measuring installation;

filling of the production magazine.

19. Shall know:

specifications on fibrous casing;

the device and methods of regulation of the measuring installation and the counter.

Paragraph 8. Bureaucrat of production of baritmassa, 3rd category

20. Characteristic of works:

conducting engineering procedure of production of baritmassa under the leadership of the bureaucrat of production of baritmassa of higher qualification;

transportation of blanfiks and its loading in mixers, melting of gelatin in the melting device;

filtering the additional components entered into paint;

observation of operation of the used devices and of system of supply of paint;

transfer of finished goods in special reservoirs to baritazhny machines;

sampling for analyses.

21. Shall know:

engineering procedure of production of baritmassa;

specifications on the components entered into paint;

the scheme of operation of the served equipment;

rules of sampling.

Paragraph 9. Bureaucrat of production of baritmassa, 4th category

22. Characteristic of works:

conducting engineering procedure of production of baritmassa;

loading of blanfiks in krasko-mixers;

addition in krasko-mixers of hot water and chemical components;

start-up of mechanical mixers and regulation of uniform hashing of paint;

unloading of paint from krasko-mixers in the device;

introduction of chemical components on the set mode;

regulation of concentration, temperature condition, process duration;

unloading from the device of ready baritmassa;

triple filtering baritmassa on alkaline filters;

adjustment of the served equipment, elimination of small defects in its work.

23. Shall know:

engineering procedure of production of baritmassa, photographic papers and their appointment;

specifications on the applied components;

the device and the principle of operation of the served equipment and the used instrumentations.

Paragraph 10. Podgotovshchik of initial material, 1 category

24. Characteristic of works:

pasting of separate pieces of black-and-white film, subbonding of rakord on the special sticking together semiautomatic devices of various systems in the conditions of not actinic lighting;

pasting quality check;

packaging of film, filling of the accompanying documentation and production magazine;

periodic survey and cleaning of the peremotochno-skleechny mechanism.

25. Shall know:

grade of film and rule of the treatment of her;

composition of the glue applied to various bases of film.

Paragraph 11. Podgotovshchik of initial material, 2nd category

26. Characteristic of works:

preparation and registration for printing kontratip, soundtracks, current negative;

check of correctness of registration of rakord, startovka, alarm signs;

subbonding of charging rakord for seal;

pasting on semiautomatic devices of various systems of separate pieces of color and panchromatic film, check of durability of pasting;

rewind and preparation of film on grades and the sizes for seal of rollers;

sorting and matching of the arriving crude film according to grades, numbers of emulsions and axes;

film charging in cartridges;

complete delivery of initial materials after seal on warehouse;

execution of the established manufacturing documentation on delivery of initial materials.

27. Shall know:

production technology of film copies;

rules of registration of film materials for seal;

design and service regulations of mechanical rewinding devices;

the lighting mode in the working room;

the device and methods of regulation of the sticking together semiautomatic devices.

Paragraph 12. Podgotovshchik of initial material, 3rd category

28. Characteristic of works:

preparation and registration of initial material for printing (kontratip, intermediate positive, soundtrack), positive film for seal of the current negative;

complete delivery and control of technical condition of initial material in the course of seal and after it;

registration of magnetic soundtracks after rewriting and check of technical condition of initial magnetic soundtracks;

combining 16 and 35-millimeter initial materials in high-capacity rolls;

execution of the accompanying documentation on seal;

correction of the minor defects found in the course of control (subbonding of the torn perforation and gluing together, replacement of worn-out rakord);

startovka of intermediate positives, kontratip and registration of soundtracks;

pasting of the current negative and installation of alarm marks on change of the tsvetosvetovy passport.

29. Shall know:

manufacturing techniques of film copies and seal of the current negative;

range of initial materials and their appointment;

bases of the optical and magnetic record of sound;

rules of drawing startovka;

design of synchronous tables and skleechny semiautomatic devices;

the principle of work copy and recorders and the used instrumentations.

Paragraph 13. Podgotovshchik of initial material, 4th category

30. Characteristic of works:

preparation and registration of the mounted negative for printing;

complete delivery and control of technical condition of negative in the course of seal and after it;

punched hole of light passports and check of compliance to their written passport;

registration of rakord in initial materials;

registration, consolidation and startovka of 32-millimeter kontratip;

consolidation of 32-millimeter negatives of rewriting of soundtracks and 70-millimetric film copies in high-capacity rolls;

measurement of density, arrangement of personnel and shrinkage of film.

matching and installation dopechatok;

Warning!!!

This is not a full text of document! Document shown in Demo mode!

If you have active License, please Login, or get License for Full Access.

With Full access you can get: full text of document, original text of document in Russian, attachments (if exist) and see History and Statistics of your work.

Get License for Full Access Now

Disclaimer! This text was translated by AI translator and is not a valid juridical document. No warranty. No claim. More info

Effectively work with search system

Database include more 50000 documents. You can find needed documents using search system. For effective work you can mix any on documents parameters: country, documents type, date range, teams or tags.
More about search system

Get help

If you cannot find the required document, or you do not know where to begin, go to Help section.

In this section, we’ve tried to describe in detail the features and capabilities of the system, as well as the most effective techniques for working with the database.

You also may open the section Frequently asked questions. This section provides answers to questions set by users.

Search engine created by SojuzPravoInform LLC. UI/UX design by Intelliants.